Please Note: If you have any of our PWMs, you do not need this product. This product was designed for those that want to run their cell without a PWM.
This device is used to control the power to your HHO cell. It provides a way to switch the cell on and off, using very low current. The actual switching of the main current to the cell is done with a relay. This allows you to control the cell using the fuel pump relay, so that the cell is only operating when the engine is actually running. This is a vital safety concern. You can also add a remote switch for your HHO system using any available switch and 2 small wires. Finally, it has a built in shunt so that you can read the amperage you are drawing by measuring the voltage between 2 terminals on the circuit board.
This is the Power Control Module described in the article Important: Minimum Safety Circuitry for HHO Installs. Please see that article for a complete description of this device.
Comes with 6' of 10 gauge wire, for connection to the battery and your cell.
This product was added to our catalog on Monday 15 August, 2011.